USER GUIDE & MAINTENANCE

MOVING YOUR ISLAND

The kitchen island arrives pre-assembled for your convenience. To make transportation easier, the appliances and features will be installed once the island is placed in your desired location. If you need to move your kitchen island in the future, to make it easier, we recommend removing the drawers and barbeque before relocating then reinstalling them in the new spot.

While you may be tempted to carry your island by the counter or from under the drawers, please avoid doing so to prevent damaging the island. Always lift the island by its base using the structure’s frame.

IMPORTANT GUIDELINES

  • Always store your gas cylinder upright and in the designated drawer to the right of your barbecue. The gas cylinder should not exceed 72 cm in height.
  • Each drawer can hold up to 20 kg. Please avoid exceeding this weight limit preventing any damages
  • Islands ordered with a sink require professional installation.
  • Plumbing must be installed by a licensed contractor to ensure safety and compliance.

KITCHEN ISLAND

  • Shield your kitchen island from the weather elements with a suitable fitted outdoor cover when not in use.
  • Cleaning your kitchen is important after each use. Clean your kitchen when it first appears dirty, rather than leaving it to worsen.
  • Clean with a soft cloth using warm water and a mild soap. Do not use cleaners containing chlorine or bleach.
  • Rinse with clean water.

APPLIANCES

For the best performance and longevity of your appliances, please refer to the User Guide and Maintenance Manual provided with each appliance. These guides include detailed instructions on proper use, cleaning, and care.

PROTECTIVE COVER

Regular Cleaning:

  • Remove dust, sand, and debris using a soft brush or cloth.
  • Shake out loose dirt before washing to prevent abrasion of the PU coating.

Washing:

  • Mix mild soap or detergent with lukewarm water.
  • Use a soft sponge or cloth to gently wipe the cover. Avoid scrubbing too hard, especially along folds or seams.
  • Rinse thoroughly with clean water to remove soap residue.
  • Avoid machine washing, handwash only.
  • Air dry completely before rolling

Spot Cleaning:

  • For grease or oil stains, use a mild dish soap solution and gently blot.
  • Avoid harsh chemicals, bleach, or solvents, these can degrade the PU coating.

All information and advice provided are to the best of our knowledge.